VISSONIC Community

What cables are needed for a 5G wireless conference system installation?

Find product answers, share suggestions, and discuss VISSONIC solutions with our support community.

Unsolved What cables are needed for a 5G wireless conference system installation?

What cables are needed for a complete 5G WiFi Wireless Conference System installation?

Do we need CAT5e cables between units, or is it truly wireless?

All Answers (1)
  • Undefined

    Yesterday 16:36
    0

    The discussion units are truly wireless — they run on rechargeable batteries and connect over 5G WiFi, so there are no cables between units.

    What you do need:

    One 5G WiFi access point (VIS-AP4C) per coverage area, connected to the network switch by CAT5e/CAT6.

    The 5G WiFi Wireless Conference Processor, also connected to the switch.

    CAT5e cable runs only between the access point, processor and switch — not to each seat.

    This is the big advantage over wired systems: the table stays clean and the room can be reconfigured without recabling. Plan for VIS-WCH1 charger boxes to recharge the units' batteries between sessions.

    Reply
Submit Answer